Arp provides torque specs for our fasteners based on using arp ultra torque.
Arp 2000 rod bolt torque 7 16.
Here is a diagram of some.
Arp supported speed demon 715 sets new land speed record new kit.
Alfa romeo 2 0l gtv.
A typical value for this reciprocating weight is in the vicinity of 20 000 lbs.
Bmc a b.
Eagle has arp custom make bolts to our specifications.
If you have an aftermarket connecting rod with an arp bolt please use the chart below to contact the rod manufacturer for the stretch torque value.
For purposes of bolt design a rule of thumb is to size the bolts and select the material for this application such that each of the 2 rod bolts has a strength of approximately 20 000 lbs.
Ford power stroke 6 7l custom age 625.
Use torque wrench to install fastener to the torque value from the chart below.
Eagle rods are offered with a variety of different bolts.
3 install rods by bringing cap and beam into alignment.
Formula vee m9 rod bolts.
We ve done the testing where we can measure the torque applied and the resulting pre loads.
Apply arp ultra torque to fastener threads and the underhead of the bolt or underside of the nut.
First let s be clear.
Do not use torque specs for off the shelf arp bolts.
Acura nsx 3 0l m9.
Corresponding to the total reciprocating weight.
Proper bolt torque is paramount to rod strength and life.
If you re not using our specs and our lube you have no real idea what pre load you re getting.
Amc 68 69 390 3 8 114 6004.
The torque values represented here are intended to be for general information only not for specific installations.
Eagle does not use off the shelf arp bolts.
Audi 2000 2005 2 7l 1995 2001 2 8l non turbo.
Ad performance scat rod bolt torque specifications rod torque specsimportant installation instructions1 disassemble rods and thoroughly clean including bolt and beam threads to remove rust preventative.
If you have a number that looks like this ap3 300 1lb.
Acura nsx 3 2l m8.
Aftermarket axle full thread thread in 12pt 1 2 20 x 1 950 uhl new kit.
2 apply arp molylube to the threads and under the head of each bolt.
The calculation of those values is solely up to the rod manufacturer.
Each of which has a different torque requirement.
